Dell Inspiron 15 7559 Ram Upgrade

How to Upgrade Dell Inspiron I 2305/2310

By Tyson Cliffton

i Jupiterimages/Photos.com/Getty Images

The Dell Inspiron One 2305 and 2310 computers accept all of the computer'southward hardware built into the monitor, so you don't have to work effectually a tower. Both models as well accept two retentiveness module slots and can back up upwards to 8 GB3 Dual Channel DDR3 SDRAM at 1333 Mhz. The hard bulldoze can exist upgraded using whatsoever three.5-inch SATA hard drive up to 7200 RPM. Fortunately, upgrading the calculator takes very piffling time and only requires a Phillips screwdriver and the new hardware components.

Step 1

Turn your Dell Inspiron 1 2305 or 2310 computer off. Disconnect any devices connected to the machine.

Pace 2

Place a pillow on the floor. Lift up your computer monitor, and then place it face up downwardly on the pillow. Remove the screws along the lesser border of the back comprehend, which are located just before the cover angles upward toward the middle of the estimator.

Step iii

Remove the four screws on the upper-edge of the stand on the lesser of the computer. Lift and remove the stand.

Footstep 4

Remove the two screws from the right side of the hard drive subclass located on the right side of the hard drive using a Phillips screwdriver. Slide the subclass to the right, and and so lift and remove the bracket.

Step five

Remove the 4 screws on superlative of the bracket connecting information technology to the hard drive. Lift and remove the subclass from the difficult drive.

Step half-dozen

Insert the new hard drive in the bracket, and then replace the four screws. Identify the bracket on the correct side of the difficult drive bay, and slide it to the left to connect it to the computer. Replace the two screws on the right side of the subclass to connect it to the computer.

Step 7

Remove the screw from the top of the memory module cover, which is located to the left of the fan. Push the comprehend up a quarter of an inch, and then remove the cover. Two memory module slots will exist exposed.

Step eight

Push the retaining clips on the short sides of the module abroad from the module. The module will tilt upward. Carefully pull the module out of its slot, and then slide the new module into the empty slot. Button the module down to lock it into place. Repeat this step to remove the other memory module. Replace the memory module cover, and then insert the screw connecting it to the estimator.

Pace ix

Slide the stand up back on the bottom part of the computer and insert the four screws connecting it to the computer. Place the dorsum comprehend on the calculator, and and so insert the two screws connecting information technology to the computer. Stand the monitor upwardly and reconnect whatsoever devices that were previously connected. When you restart the calculator, the upgrades will automatically be detected.

References

Author Bio